royal star venture technical help

yamaha venture technical support

 

Not a member? Join Today to see why so many say they are Proud to be a Venturer!



Library Home Page > 1st Generation (1983 to 1993) > Brakes
Filling Master Cylinder Tip
  Author: Archives
  Views: 5334     Votes: 5
  Print
 

Filling Brake Master Cylinders

Just did a replace on all my fluids a week ago. One real handy tip is get a piece of battery drain hose and slip it over a NEW pump oil can filled with brake fluid (DOT-3). Open the master cylinder and open the drain plugs slightly and slip the hose over the end. Pump the oil can until the fluid fills back into the master cylinder. If the fluid in the lines is bad you can sop it up until it clears up. You can then go through the standard bleeding. Get a buddy. It helps.

If you need any more help, please holler. I did front, rear and clutch in just under two hours.

Don Barnes
84 Royale

 

Last update: 07:33 AM Sunday, September 26, 2004

Related Articles:


Not a member? Join Today to see why so many say they are Proud to be a Venturer!

Copyright 2000-2013 The Venturers, Inc.
All Rights Reserved
All material on webpages under the domain venturers.org, is the property of The Venturers, Inc. These materials are protected by copyright and other intellectual property laws. You may not reproduce or retransmit the materials, in whole or in part, in any manner, without the prior written consent of The Venturers, Inc. The free information contained herein is offered in the spirit of helping others and any action or advice taken from these pages is the sole responsibility of the receiver.